Well Pump Repair in Central Maine

Well Pump Repair

The pump is the heart of your well system, and when it fails you usually find out the hard way — no water, brown water, or pressure that limps along. We diagnose and repair both submersible pumps (down in the well) and jet pumps (at the surface), test the motor, wiring, and water level, and replace the pump when it has truly failed. On Central Maine bedrock wells we pull, inspect, and reset pumps on poly or galvanized drop pipe, replace torque arrestors and check valves, and size the new pump to your well depth and yield so it does not short-cycle or run dry.

What pump failure actually looks like

Pumps rarely die all at once. The warning signs are sputtering or air in the lines, pressure that no longer reaches the top of its range, the pump running far longer than it used to, tripped breakers, or a sudden jump in your electric bill. Sand or grit in the water can mean a worn pump or a well drawing down past the pump intake. We measure amperage draw and water level to tell a worn pump apart from a wiring fault, a stuck check valve, or a low-yield well.

Repair first, replace when it makes sense

Not every pump problem is a dead pump. We repair wiring, splices, control boxes, check valves, and torque issues, and we replace the pressure switch or relay when that is the real fault. When the pump itself is gone, we pull it, inspect the drop pipe and wire on the way up, and install a correctly sized replacement — then disinfect the well before we put it back in service.

What’s included

• Submersible and jet pump diagnosis and repair
• Motor, wiring, splice, and control-box testing
• Check valve, torque arrestor, and drop-pipe service
• Correctly sized pump replacement for your well depth and yield
• Well disinfection before the system goes back in service